Filter
Top Products
233
5-5.3 VeriPHY
This section is used for running the VeriPHY Cable Diagnostics. Press to run the diagnostics.
This will take approximately 5 seconds. If all ports are selected, this can take approximately
15 seconds. When completed, the page refreshes automatically, and you can view the cable
diagnostics results in the cable status table.
NOTE: VeriPHY is only accurate for cables of length 7–140 meters.10 and 100 Mbps ports
will be linked down while running VeriPHY. Therefore, running VeriPHY on a 10 or 100 Mbps
management port will cause the switch to stop responding until VeriPHY is complete.
Web Interface
To configure a VeriPHY Cable Diagnostics Configuration in the Web interface:
1. Specify the Port you want to check.
2. Click Start.
Figure 5-5.3: The VeriPHY
Parameter description:
Port :
The port where you are requesting VeriPHY Cable Diagnostics.
Cable Status :
Port: Port number.
Pair: The status of the cable pair.
Length: The length (in meters) of the cable pair.