Filter
Top Products
Chapter 26. Global Mirror examples 375
The creation wizard then displays the “Select target LSS” panel; see Figure 26-10. Here you
select from the pull-down lists the
Storage complex, then the Storage unit, then the
Storage Image and finally the LSS, which contains the corresponding target volumes of the
Global Copy pairs. Click
Next to proceed with the third step of this wizard.
Figure 26-10 Global Copy paths creation step 2 - select the target LSS
Then the creation wizard displays the “Select source I/O ports” panel; see Figure 26-11. Here
you select, with the check boxes, the I/O ports through which you intend to connect the
source LSS to the target LSS. In the location column, four digits indicate the location of a port:
The first digit - R - is to locate the frame.
The second digit - E - is for the I/O enclosure.
The third digit - C - is for the adapter.
The fourth digit - P - is for the adapter port.
Figure 26-11 Global Copy paths creation step 3 - select the source I/O ports
Click Next to proceed with the fourth step of this wizard.