Filter
Top Products
Chapter 26. Global Mirror examples 379
In the “Select source volumes” panel (see Figure 26-17), select from the pull-down lists the
Storage complex, then the Storage unit, then the Storage Image, then the Resource type
and, if necessary, its appropriate parameter to display the list of volumes. If you have chosen
the
Resource type LSS, select from the pull-down list the LSS number that contains the
source volumes you intend to use. Then, check the boxes for the source volumes you plan to
use as Global Copy pairs in the Global Mirror session. Click
Next to proceed with the third
step of this wizard.
Then the creation wizard displays the “Select target volumes” panel; see Figure 26-18.
Figure 26-18 Global Copy creation step 3 - select the target volume 1
In this panel (see Figure 26-18), we notice that only one source volume is indicated on the top
of the panel. It means that we need to repeat this third step for each volume we have selected
during the previous second step.
Note: If paths have not been created yet, you can click Create Paths to launch the wizard
to create paths as described in the previous section.
Note: Although the following panels refer not to CKD volumes but to open systems
volumes, it applies in the very same fashion to CKD volumes.