Filter
Top Products
Configuring an E_Port Extension over an ATM WAN
7-1
7
Configuring an E_Port
Extension over an ATM
WAN
This chapter contains the procedures for configuring your UltraNet
Edge 3000 for an E_port extension over an ATM WAN using
McDATA’s UltraNet ConfigManager configuration tool.
Prior to configuring the UltraNet Edge Storage Router, you should be
familiar with Fibre Channel, Ethernet, and ATM networking
principles. You will need to gather some IP addresses for the IP
Management feature when configuring an ATM WAN. See the
UltraNet Edge Storage Router ATM WAN Configuration Worksheet in
Appendix J.
Configuring a 1x1 ATM Wide Area Network
To configure your Edge for an ATM WAN, the following eight
procedures are necessary. Complete each procedure in the order
shown below:
1. Gathering the IP Addresses
2. Starting UltraNet ConfigManager
3. Adding Nodes for an ATM WAN Configuration
4. Setting the Initial Configuration
5. Setting the License Information
6. Adding an ATM Circuit
7. Creating a Data Path
8. Delivering the Configured Network