Filter
Top Products
B-3
UltraNet Edge 3000 Placement
— For a recessed mount, position the brackets so they are
extended from the front of the UltraNet Edge 3000 unit
approximately 3 1/4”. Attach the brackets using the rear holes
(see illustration below).
NOTE: Using a screw longer than 1/4 inch will impinge on the power supply
and make it impossible to remove.
2. Position the UltraNet Edge 3000 unit in the rack. It may be
necessary to tilt the unit approximately six inches or so to clear
the rack mounting rails (a 4U opening is needed to accomplish
this).
3. Using a #2 Phillips screwdriver and four screws (two for each
bracket) designed for the rack, attach the UltraNet Edge 3000 with
the bracket ears to the equipment rack.
Sb082
Bracket Ear (2)
6-32 Flathead Undercut Screws (8)
Sb083
10-32 Screws
Approximately
6”
Equipment Rack
Mounting Rails