Filter
Top Products
11
11-2
McDATA UltraNet Edge 3000 User Guide
Upgrading the UltraNet Edge 3000 Software
Verify your Current
Software Version
Before upgrading your software, use the following procedure to
verify the current version of software from your PC:
1. Telnet to the UltraNet Edge 3000.
2. Enter the correct password if previously defined.
3. Issue the following commands to verify the current software
versions:
tm.0x00> rpm query -a
The current versions of all the software packages will be displayed.
Below is an example of how the version information is displayed.
CMNTnucleus-V3.1.1.3
CMNTdiag-V3.1.1.3
CMNTsm-V3.1.1.3
CMNTwebview-V3.2
The first three modules listed in the example above show the current
version for the UltraNet Edge 3000 OS. The last module listed shows
the current version of WebView.
Upgrading the
UltraNet Edge 3000 -
On-Site Local
This section explains all of the steps required to replace the chassis
and upgrade your UltraNet Edge 3000 to the most current software
version. This procedure is applicable when initiated by on-site
McDATA field personnel.
NOTE: This upgrade procedure only applies to UltraNet Edges currently at
version 3.1.1.1 or higher. Both UltraNet Edge 3000 units must be local.
There are several short procedures required for upgrading the
UltraNet Edge 3000 in a local environment. Follow the steps
summarized below:
1. Request License Key from Technical Support
2. Obtain Current Version of UltraNet ConfigManager
3. Power Down the UltraNet Edge 3000 Unit
4. Replace the UltraNet Edge 3000 Chassis and Update UCM
5. FTP the New UltraNet Edge 3000 Software