Filter
Top Products
8
8-2
McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 Ethernet Wide Area Network
NOTE: For help on the configuration process, click the Help button on the
active dialog box or press the F1 key.
Gathering the IP
Addresses
Before starting the configuration procedure in ConfigManager you
will need to gather the IP addresses for your network. The IP host
addresses and the completed UltraNet Edge Storage Router
Configuration IP Address Worksheet will be used as examples in the
configuration process. The worksheet is referred to as the
Configuration IP Address Worksheet throughout the remainder of this
chapter.
Figure 8-1 shows an example of a network configured with two
UltraNet Edge 3000s as a 2x2 implementation.
Figure 8-1 Sample FICON ISL with Ethernet WAN using two UltraNet Edge 3000s
Using the Configuration IP Address Worksheet in Appendix J to gather
the IP addresses and associated subnet masks to configure each
UltraNet Edge 3000.
You will need the following addresses:
Default
Gateway 1
Router/
Switch
192.168.10.3
192.168.10.1
192.168.100.1
192.168.100.4
192.168.20.3
192.168.20.1
192.168.200.1
192.168.200.4
IP Cloud
Fibre
Channel
Switch
UltraNet Edge
Storage Router
Node 10
UltraNet Edge
Storage Router
Node 20
Default
Gateway 2
Router/
Switch
Sb039
Maintenance IP
Ethernet WAN
Ethernet WAN
Maintenance IP
Fibre
Channel
Switch
Router/
Switch
192.168.101.4 192.168.201.4
IP Cloud
Router/
Switch
Fibre
Channel
Switch
Fibre
Channel
Switch