Filter
Top Products
3
3-6
McDATA UltraNet Edge 3000 User Guide
Network Design
When designing your network for an ATM WAN using the UltraNet
Edge 3000, gather the following information for both the local and
remote nodes:
NOTE: Refer to the UltraNet Edge Storage Router ATM WAN Configuration
Worksheet in Appendix J or help gathering the IP addresses and required
network criteria.
• ATM VPI/VCI information for connectivity through ATM
switches.
• Host IP addresses (Ethernet maintenance interface and ATM
WAN interface)
• Subnet information
• Default Gateway IP host address on the Ethernet maintenance
interface
• SNMP information
— System name and contact information
— Community names
— Trap Destinations
Required Network
Design Information for
an ATM Network
The following is a list of pertinent information for each network
component that you will need to know when designing your ATM
network.
UltraNet Edge 3000
• The Ethernet maintenance interface is statically configured for
auto negotiate.
• Each IP interface on the UltraNet Edge 3000 needs to be on a
separate subnet. This includes the WAN interfaces, the Ethernet
maintenance interface, and the serial interface for PPP.
• The default PPP IP host address for the UltraNet Edge 3000’s
serial interface is 192.168.1.1/28. This can be changed using
UltraNet ConfigManager.
• The default IP address structure will be defined for the ATM
WAN on subnet 192.168.144.0/24, if one is not defined using
UltraNet ConfigManager.