Filter
Top Products
7
7-26
McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 ATM Wide Area Network
5. Select either Dedicated Circuit, Fail Over, or Load Balancing in
the Network Routing Options. For more information on these
routing options, see the
“Network Routing Options” section in
Chapter 3.
• If you are creating a 1x1 configuration, the only selectable
routing type is Dedicated Circuit. All other options in this
dialog box are grayed out and ignored.
• The options selectable from this dialog box are limited by
the license key for the node. If the license key does not
provide support for the Fail Over and Load Balancing
network routing types, only the Dedicated Circuit network
routing type is selectable, and all other options on this
dialog are grayed out.
• If you have not entered the licensing information for each
node in the circuit using the License Wizard, only the
Dedicated Circuit network routing type is selectable from
this dialog box.
• If you want to change the Network Routing Type after you
have created the data paths, double-click the F/C interface
on the Network Map. Click the Network button at the
bottom of the F/C interface dialog box (FC10 - Node10)
and select the Network Routing Type. You do not need to
create the data paths again to change the Network Routing
Type.
6. Click Next.