Filter
Top Products
9
9-24
McDATA UltraNet Edge 3000 User Guide
Configuring Tape Device Extension
NOTE: If you do not know what the default gateway (the router IP address
attached to the UltraNet Edge 3000) is at this point, you can add the static
route at a later time. To add static routes at a later time, see Appendix A,
Modifying Static Routes.
15. Select Set, enter the IP Address of the router directly attached to
Node20 to set the static route.
NOTE: If you are using the Configuration IP Address Worksheet, enter the
following information:
For Node20, enter the gateway address labeled .
16. Click Next>.
The IP Circuit Wizard Configure Circuit dialog box appears.
This dialog box enables you to configure the circuit properties.