Filter
Top Products
7
Configuring an E_Port Extension over an ATM WAN
7-21
Configuring a 1x1 ATM Wide Area Network
cells/sec) are valid enabled values. This value matches the
value specified in the Peak Cell Rate field. This field is only
selectable if VBR is selected as the Quality of Service type. If
UBR or CBR is selected as the Quality of Service type, this field
is grayed out and cannot be configured.
h. Enter the Maximum Burst Size (cells/sec) in this field.
0 through 2812 (cells/sec) are valid enabled values. The
default value is 0 (cells/sec). This field is only selectable if
VBR is selected as the Quality of Service type. If UBR or CBR is
selected as the Quality of Service type, this field is grayed out
and cannot be configured.
i. Click Next>.
The ATM Circuit Wizard - Node20 - Configure IP Mgmt dialog
box appears.
This dialog box configures the IP Management link over this
circuit. Configuring IP Management over the ATM circuit is
optional.
14. To configure IP Management over this circuit, check Set, enter the
IP Address, and the Subnet Mask.