Filter
Top Products
B-4
UltraNet™ Edge Storage Router 3000 User Guide
Connecting the UltraNet Edge 3000
NOTE: Do not stack the units. The top air holes and side vents must remain
unconstricted.
Connecting the UltraNet Edge 3000
This section describes the procedures for making your initial setup
connection (Ethernet RJ-45), power connection, network interface
connections, and maintenance/diagnostics connections.
Setup Connection
This connection allows you to configure your UltraNet Edge 3000
using the UltraNet ConfigManager application.
1. Connect an Ethernet straight through Category 5 cable to the
RJ-45 connector labeled Ethernet on the UltraNet Edge 3000 unit.
2. Connect the other end of the cable to the Ethernet network
connection. The
UltraNet Edge 3000 unit must be on the same
subnet as the PC which has UltraNet ConfigManager installed on
it (consult with your systems administrator for the location).
Figure B-1 Connecting the CAT5 Cable to the UltraNet Edge 3000
Fan (4)
Sb017
Front View
Back View
Redundant Power Supply
Power Supply