Filter
Top Products
12
12-4
McDATA UltraNet Edge 3000 User Guide
Fan Assembly Installation Procedure
2. Place the UltraNet Edge 3000 unit on a level surface so the back of
the unit is facing you.
3. Using a small straight-slot screwdriver, loosen the 6-32-inch
flathead blade captive screw on the louvered fan door until it
springs open.
4. Pull the louvered fan door open until the door hinge disengages.
5. Place the fan assembly (the louvered fan door and fan unit) to the
side.
6. Disconnect the power connector by lifting up on the plastic latch
with a non-metallic tool to release the power connector (each
connector has a black and a red wire). Then remove it from the
main processing board.
7. Place the disabled fan assembly into an antistatic bag or onto the
static mat.
8. Follow the Fan Assembly Installation Procedure to install a new
fan assembly.
Fan Assembly Installation Procedure
Use the following procedure to install the fan assembly into the
UltraNet Edge 3000.
Tools Required: A small straight-slot screwdriver.
CAUTION
Attach a wrist strap and follow ESD procedures during the
handling of all electronic components.
Fan Door Captive Screw
Sb012
Hinge
Hinge Slot Latch