Filter
Top Products
12
Hardware Maintenance
12-15
OC-3 ATM Interface Card Removal Procedure
5. Replace the cover by following the Top Cover Installation
Procedure.
NOTE: To replace the Gigabit Ethernet transceiver, see the replacement
procedures found later in this chapter.
OC-3 ATM Interface Card Removal Procedure
Use the following procedure to remove the OC-3 ATM interface card
from the UltraNet Edge Storage Router.
Tools required: A small Phillips screwdriver and an adjustable
Torque driver, rated between 3 and 15 in-lbs.
CAUTION
Attach a wrist strap and follow ESD procedures (see page B-19)
during the handling of all electronic components.
1. Follow the Top Cover Removal Procedure.
2. Turn off both power supplies on the UltraNet Edge 3000.
3. Unplug the power cords.
4. Locate the OC-3 ATM interface card.
The OC-3 ATM interface card is located on the front left side of
the UltraNet Edge 3000 in I/O 3 (see illustration below).
5. Remove the two screws at the rear of the OC-3 ATM interface
card.
6. Carefully pull the OC-3 ATM interface card up. The OC-3 ATM
interface card is connected to two socketed connectors.
7. Remove the OC-3 ATM interface card from the chassis.