Filter
Top Products
7
7-22
McDATA UltraNet Edge 3000 User Guide
Configuring a 1x1 ATM Wide Area Network
NOTE: If you are using the ATM WAN Configuration Worksheet from
Appendix J for a 1x1 or 2x1 configuration, enter the IP Management address
labeled
for Node20.
For a 2x2 or 1x2 configuration, enter the IP Management address labeled
for Node20.
The IP address must be different than the Ethernet Maintenance
Interface address.
15. Click Next>.
The ATM Circuit Wizard - Configure Circuit dialog box
appears.
This dialog box enables you to configure the circuit properties.
16. To enable the Adaptive Rate Limiting feature, check the
Minimum box, and specify the minimum transmission rate. The
minimum transmission rate should be set to 92% of the
guaranteed minimum line rate, and should be less than or equal
to the maximum line rate.
17. Check the Set MTR box, and specify the maximum transmission
rate. The maximum transmission rate should be set to 92% of the
speed of the slowest network segment.
Adaptive Rate Limiting uses the minimum and maximum
trasnmission rates to dynamically determine bandwidth
allocation. If a minimum transmission rate is not set, or if it is set