Filter
Top Products
9
Configuring Tape Device Extension
9-31
Configuring Tape Device Extension
• If you are creating a 1x1 configuration, the only selectable routing
type is Dedicated Circuit. All other options in this dialog box are
grayed out and ignored.
• The selection you choose will be applied to all the Fibre Channel
Device Extension interfaces.
• The options selectable from this dialog box are limited by the
license key for the node. If the license key does not provide
support for the Fail Over and Load Balancing network routing
types, only the Dedicated Circuit network routing type is
selectable, and all other options on this dialog are grayed out.
• If you want to change the Network Routing Type after you have
created the data paths, double-click the F/C interface on the
Network Map. Click the Network button at the bottom of the F/C
interface dialog box (FCDevExt10 - Node10) and select the
Network Routing Type. You do not need to create the data paths
again to change the Network Routing Type.
The FC Device Extension DataPath Wizard - Finish dialog box
appears.
10. Click Finish to complete the configuration of this data path and
to return to the Network Map.
11. If your network requires Edge LUN mapping, proceed to the
“Static Mapping the LUNs and Filtering the Source WWN”
section below.