Filter
Top Products
2
Task 18: Set Switch Date and Time
2-75
Installation Tasks
—Hour (HH): 0 through 23.
—Minute (MM): 0 through 59.
—Second (SS): 0 through 59.
4. Click Activate to set the switch date and time and close the
Configure Date and Time dialog box.
Periodically
Synchronize Date
and Time
To set the switch to periodically synchronize date and time with the
SAN management application:
1. Click the Periodic Date/Time Synchronization check box to select the
option (check mark in the box). The Date and Time fields are
greyed out and not selectable. Perform one of the following
options:
— Click Activate to enable synchronization and close the
Configure Date and Time dialog box. The switch date and time
synchronize with the SAN management application date and
time at the next update period (at least once daily).
— Click Sync Now to synchronize the switch and SAN
management application immediately. The Date and Time
Synced dialog box displays.
Figure 2-66 Date and Time Synced Dialog Box
2. Click OK to synchronize the date and time and close the Date and
Time Synced dialog box, then click Activate to enable
synchronization and close the Configure Date and Time dialog box.