Filter
Top Products
3
3-90
McDATA® Sphereon 3032 and 3232 Fabric Switches Installation and Service Manual
Diagnostics
b. Select Clear Link Incident Alert(s). The Clear Link Incident
Alert(s) dialog box displays.
Figure 3-43 Clear Link Incident Alert(s) Dialog Box
c. Select the This port (n) only radio button (where n is the port
number) and click OK. The link incident clears.
d. Monitor port operation for approximately five minutes.
Did the link incident recur?
YES NO
↓ The problem is transient and the Fibre Channel link and
switch appear operational. Exit MAP.
35
Inspect the fiber-optic jumper cable attached to the port and ensure
the cable is not bent and connectors are not damaged. If the cable is
bent or connectors are damaged:
a. Notify the customer the port will be blocked. Ensure the
customer’s system administrator quiesces Fibre Channel frame
traffic through the port and sets the attached device offline.
b. Block the port. Refer to Block or Unblock a Port on page 4-45.
c. Remove and replace the fiber-optic jumper cable.
d. Unblock the port. Refer to Block or Unblock a Port on page 4-45.
Was a corrective action performed?
YES NO
↓ Go to step 37.
36
Monitor port operation for approximately five minutes.
Did the link incident recur?