Filter
Top Products
2
Task 25: Configure the Switch from the SANpilot Interface (Optional)
2-125
Installation Tasks
c. The Attached WWN column contains read-only fields that list
the world wide names of attached Fibre Channel devices.
Click the check box in the Use Attached column to indicate the
world wide name specified in the Attached WWN column is to
be used for port binding. After activation, the attached WWN
appears in the Bound WWN column.
2. Click Activate to save the information. The message Your changes
to the port binding configuration have been successfully
activated appears.
Configure Switch
Binding
Perform this procedure to configure switch binding by attached
devices (nodes). The SANtegrity™ feature must be installed to access
this control. Refer to Install PFE Keys (Optional) on page 2-132 for
instructions. If the feature is not installed, the message This Feature
Not Installed appears. To configure switch binding:
1. At the Configure panel, click the Switch Binding tab. The Security
page displays with the Switch Binding tab selected (Figure 2-101).
Figure 2-101 Configure Panel (Security Page with Switch Binding Tab)