Filter
Top Products
3
MAP 0600: Port Failure and Link Incident Analysis
3-89
Diagnostics
b. At the Switch Binding - Membership List dialog box ensure the
Switch Membership List is updated and correct for each switch,
then click Activate for each switch. The switch binding feature is
consistently enabled for both switches.
Did updating the switch membership lists solve the problem?
NO YES
↓ The switch appears operational. Exit MAP.
Contact the next level of support. Exit MAP.
32
A port connection is not allowed because of a Computer Network
Technologies (CNT) wide area network (WAN) extension mode
mismatch. Based on switch-to-switch differences between the ELP
maximum frame sizes allowed, a connection was not allowed to a
switch set to CNT WAN extension mode.
Contact McDATA support personnel to obtain software maintenance
release 4.02.00. This release is required to correct the problem and
allow McDATA switches to communicate with CNT UltraEdge WAN
Gateways. Exit MAP.
33
The switch and attached device are performing a Fibre Channel link
reset. This is a transient state. Wait approximately 30 seconds and
inspect port state and LED behavior.
Did the link recover and resume operation?
NO YES
↓ The Fibre Channel link and switch appear operational.
Exit MAP.
Go to step 1.
34
A link incident message appeared in the Link Incident Log or in the
Link Incident field of the Port Properties dialog box; or an event code
581, 582, 583, 584, 585, or 586 was observed at the console of an
OSI server attached to the switch reporting the problem.
Clear the link incident for the port.
a. At the Hardware View, right-click the port. A pop-up menu
appears.