Filter
Top Products
Virtual Private Networking Using IPSec and L2TP Connections
216
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Figure 129.
3. Specify the settings that are explained in the following table.
Table 49. VPN client IPSec configuration settings
Setting Description
VPN Client address Either enter 0.0.0.0
as the IP address, or enter a virtual IP address that is used by
the VPN client in the wireless VPN firewall’s LAN; the computer (for which the VPN
client opened a tunnel) appears in the LAN with this IP address.
Address Type Select Sub
net address from the drop-down list. This selection defines which
addresses the VPN client can communicate with after the VPN tunnel is
established.
Remote LAN address Enter 192.16
8.1.0 as the remote IP address (that is, LAN network address) of the
gateway that opens the VPN tunnel.
Subnet mask Enter 255
.255.255.0 as the remote subnet mask of the gateway that opens the VPN
tunnel.
ESP Encryption Select 3DES as the encryption algorithm from the drop-down list.
Authentication Select SH
A-1 as the authentication algorithm from the drop-down
list.
Mode Select Tu
nnel as the encapsulation mode from the drop-down list.