Filter
Top Products
LAN Configuration
61
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
3. Enter the settings as explained in the following table:
Table 11. Add VLAN Profile screen settings
Setting Description
VLAN Profile
Profile Name Enter a unique name for the VLAN profile.
VLAN ID Enter a unique ID number for the VLAN profile. No two VLANs can have the same
VLAN ID number.
Note: You can enter VLAN IDs from 2 to 4089. VLAN ID 1 is reserved for the
default VLAN; VLAN ID 4094 is reserved for the DMZ interface.
Port Membership
P
ort 1, Port 2, Port 3,
Port 4, Port 5, Port 6,
Port 7, and
Port 8 / DMZ
Select one, several, or all port check boxes to make the ports members of this
VLAN.
Note: A port that is defined as a member of a
VLAN profile can send and receive
data frames that are tagged with the VLAN ID.
IP Setup
IP Address
Enter the IP address of the wireless VPN firewall (the factory default address is
192.168.1.1).
Note: Always make sure that the LAN port IP ad
dress and DMZ port IP address
are in different subnets.
Note: If you change the LAN IP address of
the VLAN while being connected
through the browser to the VLAN, you are disconnected. You then need to open
a new connection to the new IP address and log in again. For example, if you
change the default IP address 192.168.1.1 to 10.0.0.1, you now need to enter
https://10.0.0.1 in your browser to reconnect to the web management interface.
Subnet Mask Enter the IP subnet mask. The subnet mask speci
fies the network number portion
of an IP address. Based on the IP address that you assign, the wireless VPN
firewall automatically calculates the subnet mask. Unless you are implementing
subnetting, use 255.255.255.0 as the subnet mask (computed by the wireless
VPN firewall).
DHCP
Disable DHCP Server If another device on your network is the DHCP server for the VLAN, or if you will
manually configure the network settings of all of your computers, select the
Disable DHCP Server radio button to disable the DHCP server. Except for the
default VLAN for which the DHCP server is enabled, this is the default setting.