Filter
Top Products
Virtual Private Networking Using IPSec and L2TP Connections
258
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
2. Specify the following default lifetimes in seconds to match the configuration on the wireless
VPN firewall:
• Authentica
tion (IKE), Default. Enter 3600 seconds.
Note: The default setting is 28800 seconds (8 hours). However, for a Mode
Config
configuration, NETGEAR recommends 3600 seconds (1 hour).
• Encryption (IPSe
c), Default. Enter 3600 seconds.
3. Select the Dead Peer
Detection (DPD) check box, and configure the following DPD settings
to match the configuration on the wireless VPN firewall:
• Check In
terval. Enter 30 seconds.
• Max
. number of entries. Enter 3 retries.
• Delay be
tween entries. Leave the default delay setting of 15 seconds.
4. Click Apply to
use the new settings immediately, and click Save to keep the settings for
future use.
The Mode Config configuration of the VPN client is n
ow complete.
Test the Mode Config Connection
To test the Mode Config connection from the VPN client to the wireless VPN firewall:
1. Right-click th
e system tray icon, and select Open tunnel ‘Tunnel_ModeConfig’.
Figure 154.
When the tunnel opens successfully, the Tunnel opened message displays above the
system tray, and the VPN client displays a green icon in the system tray.
Figure 155.