Filter
Top Products
Monitor System Access and Performance
355
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Configure Gateway 2 at Site 2
To create a gateway-to-gateway VPN tunnel to Gateway 1, using the IPSec VPN wizard:
1. Select VPN > IPSec VPN
> VPN Wizard. The VPN Wizard screen displays.
2. Conf
igure a gateway-to-gateway VPN tunnel using the following information:
• Con
nection name. Any name of your choice
• Pre
-shared key. The same key as you configured on Gateway 1
• Remote W
AN IP address. 10.0.0.1
• L
ocal WAN IP address. 10.0.0.2
• Remote L
AN IP Address. 192.168.10.0
• Remote L
AN subnet mask. 255.255.255.0
3. Click App
ly to save the settings.
To change the local IP address in the VPN policy:
1. Select VPN > IPSec VPN
> VPN Policies. The VPN Policy screen displays.
2. Next to th
e policy name for the Gateway 2–to–Gateway 1 autopolicy, click Edit. The Edit
VPN Policy screen displays.
3. In the Genera
l section of the screen, clear the Enable NetBIOS check box.
4. In the T
raffic Selector section of the screen, make the following changes:
• F
rom the Local IP drop-down list, select Single.
• I
n the Start IP fields, type 10.0.0.2, which is the WAN IP address of Gateway 2.
5. Click App
ly to save the settings.
To specify the syslog server that is connected to Gateway 1:
1. Select Monitoring
> Firewall Logs & E-mail. The Firewall Logs & E-mail screen
displays.
2. Enable
the syslog server and specify its IP address at Site 1. Enter 192.168.10.2 as the IP
address.
3. Click App
ly to save the settings.
Note: The VPN tunnel should be established automatically, and the
syslogs should be sent to the syslog server at Site 1. You can use
the IPSec VPN Connection Status screen to verify the connection.