Filter
Top Products
Virtual Private Networking Using IPSec and L2TP Connections
256
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Note: This is the name for the IPSec configuration that is used only for the
VPN client, not during IPSec negotiation. You can view and change this name
in the tree list pane. This name needs to be a unique name.
The IPSec pane displays in the Conf
iguration Panel screen, with the IPSec tab selected
by default:
Figure 152.
3. Specify the settings that are explained in the following table.
Table 61. VPN client IPSec configuration settings (Mode Config)
Setting Description
VPN Client
address
This field is masked out because Mode Config is selected. After an IPSec connection is
established, the IP address that is issued by the wireless VPN firewall displays in this field
(see Figure 157 on
page 260).
Address Type Select Subnet address from the drop-down list.
Remote host
ad
dress
The address that you need to enter depends on whether you have specified a LAN IP
network address in the Local IP Address field on the Add Mode Config Record screen of
the wireless VPN firewall:
• If you left the Local IP Address field blank, enter the wireless VPN firewall’s default LAN
IP addre
ss as the remote host address that opens the VPN tunnel. For example, enter
192.168.1.1.
• If you specified a LAN IP network address in the Local IP Address field, enter the
a
ddress that you specified as the remote host address that opens the VPN tunnel.