Filter
Top Products
LAN Configuration
99
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
2. Click the Add table button under the Static Routes table. The Add Static Route screen
displays:
Figure 50.
3. Enter the settings as explained in the following table:
4. Click App
ly to save your settings. The new static route is added to the Static Routes table.
Table 24. Add Static Route screen settings for IPv4
Setting Description
Route Name The route name for the static route (for purposes of identification and
management).
Active To make the static route effective, select the Active check box.
Note: A route can be added to the table and made inactive if not needed. This
allows you to use routes as needed without deleting and re-adding the entry. An
inactive route is not advertised if RIP is enabled.
Private If you want to limit access to the LAN only, select the Private check box. Doin
g so
prevents the static route from being advertised in RIP.
Destination IP Address The destination IP address of the host or network to which the route leads.
Subnet Mask The IP subnet mask of the host or network to which the route leads. If the
destination is a single host, enter 255.255.255.255.
Interface From the drop-down list, select the physical or virtual network interface (WAN,
VLAN, or DMZ interface) through which the route is accessible.
Gateway IP Address The gateway IP address through which the destination host or network can be
reached.
Metric The priority of the route. Select a value between 2 and 15. If multiple routes to the
same destination exist, the route with the lowest metric is used.