Filter
Top Products
User Guide for Polycom® RMX™ 500 and Polycom® RMX™1000 Systems
(Conference on Ports)
2-5
Parameter Description
IP Address Set the IP address for this network port.
Subnet Mask Set the Subnet Mask for this network port.
Gateway
Set the gateway address of this port. If Set as Default is
selected and no matched static routes are found, the
system packets will be transmitted via this gateway by
default. In this case, a default route is displayed in the list
of Advanced Setting -> Routers page. For details, see
Routers.
NAT
The Network Address Translation (NAT) function of the
system enables you to translate the private network IP
address of packet into a public network IP address before
transmission. To enable NAT, select this check box and
then set the public network IP address to be displayed to
the outside in the NAT IP field.
Obtain DNS Server
Address Automatically
Used in combination with the DHCP option. When the
DHCP check box is selected, this option allows you to
obtain the DNS server address automatically from a
DHCP server in the network.
Preferred/Alternate
DNS Server
If you did not select the option for automatic DNS address
discovery, you must enter the preferred/alternate DNS
server addresses here for the system to resolve domain
names.
LAN Speed
Set the speed/duplex modes for LAN ports. The system
supports the 10/100M Full Duplex or Half Duplex mode
and the 1000M Network mode. You can also select Auto
to use auto-negotiation.
Note:
Contact the network administrator before setting
"LAN Speed" to ensure that the link rate of switch is
matched with the MCU port.
Configuring Other Network Options (Optional)
You can configure other network parameters according to the following
procedure:
1 Click the "IP Network Services" configuration item in the "RMX
Management" pane.
2 In the "IP Network Services" configuration pane, double-click or
right-click "LAN 1->Properties".
3 Click the "Routers" tab, and set the routing table information according to
the network topology.