Filter
Top Products
E6580757
H-1
8
8. Monitoring the operation status
8.1 Status monitor mode
In this mode, you can monitor the operation status of the inverter.
To display the operation status during normal operation:
Press the
key twice.
Setting procedure (eg. operation at 60Hz)
Item displayed
Key
operated
LED
display
Communi-
cation No.
Description
The operation frequency is displayed (during op-
eration). (When the standard monitor display se-
lection parameter
is set at 0 [operation frequency])
Parameter setting
mode
The first basic parameter "Automatic accelera-
tion/deceleration ( )" is displayed.
Operation
frequency
FE00
The operation frequency is displayed (during op-
eration).
Direction of
rotation
FE01
The direction of rotation is displayed.
( : forward run, : reverse run)
Operation fre-
quency command
FE02
The operation frequency command value is dis-
played.
Load current FE03
The inverter output current (load current) is dis-
played. (Default setting : unit %)
Input (DC) voltage FE04
The inverter input (DC) voltage is displayed.
(Default setting: unit %)
Output voltage FE05
The inverter output voltage is displayed. (Default
setting: unit %)
Input terminal FE06
The ON/OFF status of each of the control signal
input terminals (F, R, RST, S1, S2 and S3) is dis-
played in bits.
ON:
OFF:
Output terminal FE07
The ON/OFF status of each of the control signal
output terminals (RY, OUT and FL) is displayed in
bits.
ON:
OFF:
(Continued overleaf)
Note 1
Note 2
Note 3
Input terminal
(S3)
Input terminal
(S2)
Input terminal (F)
Input terminal (R)
Input terminal (RST)
Input terminal (S1)
Output terminal (FL)
Output terminal (OUT)
Output terminal (RY)