E6580757
D-5
4
■ Example of parameter setting
The steps in setting are as follows.
Example of changing the dynamic braking selection
from 0 to 1.
Key operated LED display Operation
Displays the operation frequency (operation stopped). (When stan-
dard monitor display selection is set to [operation fre-
quency])
Press the MON key to display the first basic parameter
(automatic acceleration/deceleration).
Press either the key or the key to change to the parameter
group .
Press the ENTER key to display the first extended parameter
Press the key to change to the dynamic braking selection
.
Pressing the ENTER key allows the reading of parameter setting.
Press the key to change the dynamic braking selection from
to .
Pressing the ENTER key alternately flashes on and off the parameter
and changed value and allows the save of those values.
If there is anything you do not understand during this operation, press the MON key several times to
start over from the step of display.
4.1.3 Search and resetting of changed parameters
Automatically searches for only those parameters that are programmed with values different from the stan-
dard default setting and displays them in the user parameter group . Parameter setting can also be
changed within this group.
Notes on operation
• When a value is reprogrammed that is the same as the standard value, there will be no display within
.
• The parameters programmed by the setup parameter are also displayed as changed parameters.