Filter
Top Products
E6580757
D-6
4
■ How to search and reprogram parameters
The operations of search and resetting of parameters are as follows.
Key operated LED display Operation
Displays the operation frequency (operation stopped). (When stan-
dard monitor display selection is set to [operation fre-
quency])
Press the MON key to display the first basic parameter
(automatic acceleration/deceleration).
Press either the key or the key to select " ".
Press the ENTER key to enable the user parameter automatic edit
function.
or
↓
Searches for parameters that are different in value from the standard
default setting and displays those parameters. Press the ENTER key
or the key to change the parameter displayed. (Pressing the
key moves the search in the reverse direction).
Press the ENTER key to display the set value.
Press the key and key to change set value.
Press the ENTER key to save the changed value. The parameter
name and the programmed value will flash on and off alternately.
Use the same steps as those given above to display parameters that
you want to search for or change setting with the key and key.
When appears again, the search is ended.
Parameter
display
↓
↓
A search can be canceled by pressing the MON key. Press the MON
key once while the search is underway to return to the display of pa-
rameter setting mode.
After that you can press the MON key to return to the status monitor
mode or the standard monitor mode (display of operation frequency).
If there is something that you do not understand during this operation, press the key several
times and start over again from the step of display.