Filter
Top Products
RIP 233
Traffic Sharing Across
RIP Interfaces
Equal-cost routes are routes with the same destination but different next hop
addresses in a routing table. After traffic sharing across RIP interfaces is enabled, the
system averagely distributes the traffic to its RIP interfaces through equal-cost routes.
Configuration Procedure
You can perform the following operations to configure traffic sharing across RIP
interfaces.
Displaying and
Debugging RIP
After configuring RIP, enter the
display command in any view to display the RIP
configuration, and to verify the effect of the configuration. Enter the
debugging
command in User View to debug the RIP module. Enter the
reset command in RIP
View to reset the system configuration parameters of RIP.
Display Command for RIP Interfaces
Use the command display rip interface to display information about RIP interfaces.
Example: Typical RIP
Configuration
Networking Requirements
As shown in Figure 55, Switch C connects to the subnet 117.102.0.0 through the
Ethernet port. The Ethernet ports of Switch A and Switch B are connected to the
networks 155.10.1.0 and 196.38.165.0 respectively. Switch C, Switch A and Switch B
are connected using Ethernet 110.11.2.0. Correctly configure RIP to ensure that
Switch C, Switch A and Switch B can interconnect.
Table 219 Configure traffic sharing across RIP interfaces
Operation Command Description
Enter system view system-view -
Enter RIP view rip -
Enable traffic sharing across RIP
interfaces
traffic-share-across-interface Required
By default, traffic sharing across
RIP interfaces is disabled.
Display the current running
state and configuration
information of the RIP protocol
display rip You can execute this command
in any view.
Table 220 Displaying and Debugging RIP
Operation Command
Display the current RIP running state and
configuration information
display rip
Enable the RIP debugging information debugging rip packet
Disable the RIP debugging information undo debugging rip packet
Enable the debugging of RIP receiving packet debugging rip receive
Disable the debugging of RIP receiving packet undo debugging rip receive
Enable the debugging of RIP sending packet debugging rip send
Disable the debugging of RIP sending packet undo debugging rip send
Reset the system configuration parameters of RIP reset