Filter
Top Products
480 CHAPTER 22: FILE SYSTEM MANAGEMENT
Sending the Information
to the Log Buffer
To send information to the log buffer, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 543 Enabling/Disabling Info-center
Info-center is enabled by default. After info-center is enabled, system performances
are affected when the system processes much information because of information
classification and outputting.
2 Configuring to output information to the log buffer
Perform the following operation in System View.
Table 544 Configuring to Output Information to Log Buffer
3 Configuring the information source on the Switch
With this configuration, you can define the information that is sent to the log buffer:
generated by which modules, information type, information level, and so on.
Perform the following operation in System View:
Table 545 Defining the Information Source
modu-name specifies the module name; default represents all the modules; level
refers to the severity levels;
severity specifies the severity level of information. The
information with the level below it will not be output.
channel-number specifies the
channel number and
channel-name specifies the channel name.
When defining the information sent to the log buffer,
channel-number or
channel-name must be set to the channel that corresponds to the Console direction.
Every channel has been set with a default record, whose module name is default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there is
no specific configuration record for a module in the channel, use the default one.
Disable terminal display function of trap information undo terminal trapping
Operation Command
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
Operation Command
Output information to log buffer info-center logbuffer [ channel {
channel-number | channel-name } ] [ size
buffersize ]
Cancel the configuration of
outputting information to log buffer
undo info-center logbuffer [ channel |
size ]
Operation Command
Define information
source
info-center source { modu-name | default } channel {
channel-number | channel-name } [ { log | trap | debug
}* { level severity | state state }* ]
Cancel the
configuration of
information source
undo info-center source { modu-name | default } channel
{ channel-number | channel-name }