Filter
Top Products
472 CHAPTER 22: FILE SYSTEM MANAGEMENT
1 Sending the information to loghost.
Table 523 Sending the Information to Loghost
2 Sending the information to the control terminal.
Table 524 Sending the Information to the Control Terminal.
Device Configuration Default Value Configuration Description
Switch Enable info-center By default, info-center
is enabled.
Other configurations are valid only if
the info-center is enabled.
Set the information
output direction to
loghost
- The configuration about the loghost on
the Switch and that on loghost must be
the same; otherwise the information
cannot be sent to the loghost correctly.
Set information
source
- You can define which modules and
information to be sent out and the
time-stamp format of information, and
so on. You must turn on the Switch of
the corresponding module before
defining output debugging
information.
Loghost Refer to
configuration cases
for related log host
configuration
- -
Device Configuration Default Value Configuration Description
Switch Enable info-center By default, info-center
is enabled.
Other configurations are valid only
if the info-center is enabled.
Set the information output
direction to Console
- -
Set information source - You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
turn on the Switch of the
corresponding module before
defining output debugging
information.
Enable terminal display
function
- You can view debugging
information after enabling
terminal display function