Filter
Top Products
Logging Function 479
modu-name
specifies the module name; default represents all the modules; level
refers to the severity levels;
severity specifies the severity level of information. The
information with the level below it will not be output.
channel-number specifies the
channel number and
channel-name specifies the channel name.
When defining the information sent to Telnet terminal or dumb terminal,
channel-number or channel-name must be set to the channel that corresponds to
the Console direction.
Every channel has been set with a default record, whose module name is
default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there is
no specific configuration record for a module in the channel, use the default one.
When there are more than one Telnet users or monitor users at the same time, some
configuration parameters should be shared among the users, such as module-based
filtering settings and severity threshold. When a user modifies these settings, it will be
reflected on other clients.
If you want to view the debugging information of some modules on the Switch, you
must select
debugging as the information type when configuring information source,
meantime using the
debugging command to turn on the debugging Switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View.
Table 541 Configuring the Output Format of Time-stamp
4 Enabling terminal display function
To view the output information at the Telnet terminal or dumb terminal, you must first
enable the corresponding log, debugging and trap information functions at the
Switch.
For example, if you have set the log information as the information sent to the Telnet
terminal or dumb terminal, you need to use the
terminal logging command to
enable the terminal display function of log information on the Switch, then you can
view the information at the Telnet terminal or dumb terminal.
Perform the following operation in User View.
Table 542 Enabling Terminal Display Function
Operation Command
Configure the output format of the
time-stamp
info-center timestamp { log | trap |
debugging } { boot | date | none }
Output time-stamp is disabled undo info-center timestamp { log | trap |
debugging }
Operation Command
Enable terminal display function of log, debugging and trap
information
terminal monitor
Disable terminal display function of the above information undo terminal monitor
Enable terminal display function of debugging information terminal debugging
Disable terminal display function of debugging information undo terminal debugging
Enable terminal display function of log information terminal logging
Disable terminal display function of log information undo terminal logging
Enable terminal display function of trap information terminal trapping