Filter
Top Products
Logging Function 487
Networking diagram
Figure 128 Schematic Diagram of Configuration
Configuration Procedure
1 Enabling info-center
[SW5500]info-center enable
Set the host with the IP address of 202.38.1.10 as the loghost; set the severity level
threshold value as informational, set the output language to English; set all the
modules are allowed output information.
[SW5500]info-center loghost 202.38.1.10 facility local7 language
english
[SW5500]info-center source default channel loghost log level
informational
2 Configuration on the loghost
This configuration is performed on the loghost.
a Perform the following command as the super user (root).
# mkdir /var/log/SW5500
# touch /var/log/SW5500/information
b Edit file /etc/syslog.conf as the super user (root), add the following
selector/actor pairs.
# SW5500 configuration messages
local7.info /var/log/SW5500/information
Note the following points when editing /etc/syslog.conf:
(1) The note must occupy a line and start with the character #.
(2) There must be a tab other than a space as the separator in selector/actor pairs.
(3) No redundant space after file name.
(4) The device name and the acceptant log information level specified in
/etc/syslog.conf must be consistent with info-center loghost and info-center loghost
a.b.c.d facility configured on the Switch. Otherwise, the log information probably
cannot be output to the loghost correctly.
Swit ch
PC
Net work
Swit chSwit ch
PC
Net work