Filter
Top Products
Configuring Cluster Parameters 609
Configuring Cluster
Parameters
Displaying and
Maintaining Cluster
Configurations
You can view the configuration information of a cluster with the display commands,
which can be executed in any view.
Table 668 Configure cluster parameters
Operation Command Remark
Enter system view system-view —
Enter cluster view cluster —
Add a candidate
device to a cluster
add-member [ member-number
] mac-address H-H-H [
password password ]
This is to add a new member.
Arguments member-number, H-H-H
and password are the ID, MAC address
and password of the member device
respectively.
Remove a member
from the cluster
delete-member
member-number
Optional
This is to remove a member from the
cluster.
Reset a specified
member device
reboot member { member-num
| mac-address H-H-H } [
eraseflash ]
Optional
Exit cluster view quit —
Exit system view quit —
Switch between the
management device
and member devices
cluster switch-to {
member-number | mac-address
H-H-H | administrator }
Optional
This is to switch to a member device
according to the MAC address.
Table 669 Display and maintain cluster configurations
Operation Command Remark
Display global NDP
configuration
information including
NDP packet interval
and hold time
display ndp Optional
The display command can be
executed in any view.
Display neighbor
information collected
through port NDP
display ndp interface port-list Optional
The display command can be
executed in any view.
Display global NTDP
information
display ntdp Optional
The display command can be
executed in any view.
Display device
information collected
through NTDP
display ntdp device-list [
verbose ]
Optional
The display command can be
executed in any view.
Display state and basic
configuration
information of a
cluster
display cluster Optional
The display command can be
executed in any view.
Display candidate
devices of a cluster
display cluster candidates [
mac-address H-H-H | verbose ]
Optional
The display command can be
executed in any view.
Display cluster
member information
display cluster members [
member-num | verbose ]
Optional
The display command can be
executed in any view.
Clear the NDP
statistics on a port
reset ndp statistics [ interface
port-list ]
Optional