Filter
Top Products
456 CHAPTER 22: FILE SYSTEM MANAGEMENT
Device Management With the device management function, the Switch can display the current running
state and event debugging information about the unit, thereby implementing the
maintenance and management of the state and communication of the physical
devices. In addition, there is a command available for rebooting the system, when
some function failure occurs.
The device management configuration task is simple. As far as a user is
concerned, it is mainly to display and debug the device management.
Device Management
Configuration
Rebooting the Switch
It is necessary to reboot the Switch when failure occurs.
Perform the following configuration in User View.
Table 501 Reboot the Switch
Enabling the Timing Reboot Function
After enabling the timing reboot function on the Switch, the Switch will be
rebooted at the specified time.
Perform the following configuration in User View, and the display schedule
reboot
command can be performed in any view.
Table 502 Reboot the Switch
Designating the APP Adopted when Booting the Switch Next Time
In the case that there are several APPs in the Flash Memory, you can use this
command to designate the APP adopted when booting the Switch next time.
Perform the following configuration in User View.
Table 503 Designate the APP Adopted when Booting the Switch Next Time
Operation Command
Reboot the Switch reboot [ unit unit-id ]
Operation Command
Enable the timing reboot function of the
Switch, and set specified time and date
schedule reboot at hh:mm [
yyyy/mm/dd ]
Enable the timing reboot function of the
Switch, and set waiting time
schedule reboot delay { hhh:mm | mmm
}
Cancel the parameter configuration of timing
reboot function of the Switch
undo schedule reboot
Check the parameter configuration of the
reboot terminal service of the current Switch
display schedule reboot
Operation Command
Designate the APP adopted when booting the
Switch next time
boot boot-loader file-url