Filter
Top Products
RSPAN Features 383
Configuration
Procedures in the Source
Switch
Configuration
Procedures in the
Intermediate Switch
Table 404 Configuration procedures in the source switch
Operation Command Description
Enter system view system-view —
Establish Remote-probe
VLAN, and enter VLAN view
vlan vlan-id The parameter vlan-id represents
the ID of the Remote-probe VLAN.
Define the current VLAN as
Remote-probe VLAN
remote-probe vlan enable Required.
Exit the current view quit —
Enter the Ethernet port view
of Trunk ports
interface interface-type
interface-number
—
Configure Trunk ports so that
packets of the Remote-probe
VLAN can pass through
port trunk permit vlan
remote-probe-vlan-id
Required.
Exit the current view quit —
Configure the source group
of remote mirroring
mirroring-group group-id
remote-source
Required.
Configure the source ports of
remote mirroring
mirroring-group group-id
mirroring-port
mirroring-port-list { both |
inbound | outbound }
Required.
Configure the reflector ports
of remote mirroring
mirroring-group group-id
reflector-port reflector-port
Required.
The reflector ports of remote
mirroring cannot enable STP, and
have to be Access ports.
The reflector ports cannot have
the vlan-vpn commands
configured.
Configure the remote-probe
VLAN for the source group of
remote mirroring
mirroring-group group-id
remote-probe vlan
remote-probe-vlan-id
Required.
Display the configuration for
the source group of remote
mirroring
display mirroring-group
remote-source
Optional.
The display command can be
used under any view.
Table 405 Configuration procedures in the intermediate switch
Operation Command Description
Enter system view system-view —
Establish remote-probe VLAN,
and enter VLAN view
vlan vlan-id The parameter vlan-id
represents the ID of the
remote-probe VLAN.
Exit the current view quit —
Enter the Ethernet port view of
Trunk ports
interface interface-type
interface-number
—
Configure Trunk ports so that
packets in the remote-probe
VLAN can pass through
port trunk permit vlan
remote-probe-vlan-id
Required.
This configuration is necessary
for ports of intermediate
switch that are connected with
the source switch or the
destination switch.