Filter
Top Products
User Interface Configuration 49
auto-execute command The following command is used to automatically run a
command after you log in. After a command is configured to be run automatically, it
will be automatically executed when you log in again.
This command is usually used to automatically execute the
telnet command on the
terminal, which will connect the user to a designated device automatically.
Perform the following configuration in User Interface View.
Note the following points:
■ After executing this command, the user interface can no longer be used to carry
out the routine configurations for the local system. Use this command with
caution.
■ Make sure that you will be able to log in the system in another way and cancel the
configuration, before you use the
auto-execute command command and save the
configuration.
Telnet 10.110.100.1 after the user logs in through VTY0 automatically.
[SW5500-ui-vty0]auto-execute command telnet 10.110.100.1
When a user logs on through VTY 0, the system will run telnet 10.110.100.1
automatically.
Displaying and
Debugging User
Interface
After the above configuration, use the display command in any view to display the
running of the user interface configuration, and to verify the effect of the
configuration.
Use the
free command in User View to clear a specified user interface.
Table 28 Configuring to Automatically Run the Command
Operation Command
Configure to automatically run the command auto-execute command text
Configure not to automatically run the
command
undo auto-execute command
Table 29 Displaying and Debugging User Interface
Operation Command
Clear a specified user interface free user-interface [ type ] number
Display the user application information
of the user interface
display users [ all ]
Display the physical attributes and some
configurations of the user interface
display user-interface [ type number |
number ] [ summary ]