Filter
Top Products
Dynamic VLAN Assignment 419
Setting Attributes of the
Local User
The attributes of a local user include its password display mode, state, service type
and some other settings.
Setting the Password Display Mode
Perform the following configurations in System View.
Table 447 Setting the Password Display Mode of Local Users
auto means that the password display mode will be the one specified by the user at
the time of configuring the password (see the
password command in Table 448 for
reference), and
cipher-force means that the password display mode of all the
accessing users must be in cipher text.
Setting the Attributes of Local Users
Perform the following configurations in Local User View.
Table 448 Setting/Removing the Attributes Concerned with a Specified User
Note the following two items when you configure these service types: SSH, Telnet or
Terminal.
■ When you configure a new service type for a user, the system adds the requested
service-type to any existing configuration. For example, if the user previously had
just Telnet access, and SSH was added, the user would now have access to both
Telnet and SSH.
■ You can set user level when you configure a service type. If you set multiple service
types and specify the user levels, then only the last configured user level is valid.
Some of the service types allow a user-privilege level to be entered as an optional
extra parameter. For example Telnet, Terminal and SSH.
Operation Command
Set the password display mode of
local users
local-user password-display-mode {
cipher-force | auto }
Cancel the configuration of
password display mode
undo local-user password-display-mode
Operation Command
Set a password for a specified user password { simple | cipher } password
Remove the password set for the
specified user
undo password
Set the state of the specified user state { active | block }
Set a priority level for the user level level
Restore the default priority level undo level
Set a service type for the specified
user
service-type { ftp [ ftp-directory
directory ] | lan-access | { ssh | telnet |
terminal }* }
Cancel the service type of the
specified user
undo service-type { ftp [ ftp-directory ]
| lan-access | { ssh | telnet | terminal
}* [ level level ] }
Configure the attributes of
lan-access users
attribute { ip ip_address | mac mac_address
| idle-cut second | access-limit
max_user_number | vlan vlanid | location {
nas-ip ip_address port portnum | port
portnum } }*
Remove the attributes defined for
the lan-access users
undo attribute { ip | mac | idle-cut |
access-limit | vlan | location }*