AMD LX 700@0.8W Computer Hardware User Manual


 
350 AMD Geode™ LX Processors Data Book
Display Controller Register Descriptions
33234H
6.6.13 Interrupt and GenLock Registers
6.6.13.1 DC GenLock Control (DC_GENLK_CTL)
Settings written to this register do not take effect until the start of the frame or interlaced field after the timing register
update bit (DC Memory Offset 008h[6]) is set.
DC Memory Offset 0D4h
Typ e R /W
Reset Value xxxxxxxxh
DC_GENLK_CTL Register Map
313029282726252423222120191817161514131211109876543210
FLICK_SEL RSVD
ALPHA_FLICK_EN
FLICK_EN
VIP_VIDEO_OK
GENLOCK_ACTIVE
SKEW_WAIT
VIP_VSYNC_WAIT
GENLK_TO_EN
GENLK_EN
GENLK_SKW
DC_GENLK_CTL Bit Descriptions
Bit Name Description
31:28 FLICK_SEL Flicker Filter Select. When the flicker filter is enabled (FLICK_EN, bit 24 = 1), this field
selects the weighting of the three taps in this vertical filter:
0000: 0, 1, 0 (top, middle, bottom)
0001: 1/16, 7/8, 1/16
0010: 1/8, 3/4, 1/8
0100: 1/4, 1/2, 1/4
0101: 5/16, 3/8, 5/16
All other combinations in this field are reserved.
27:26 RSVD Reserved. Set to 0.
25 ALPHA_FLICK_
EN
Alpha Flicker Filter Enable. If set, this bit enables flicker filtering of the alpha value
when the flicker filter is enabled (FLICK_EN, bit 24 = 1). If the flicker filter is enabled and
this bit is cleared, the alpha value of the center pixel is passed through the flicker filter
unchanged.
24 FLICK_EN Flicker Filter Enable. Enables the 3-tap vertical flicker filter (primarily used for interlaced
modes). When set, the graphics output is filtered vertically using the coefficients as indi-
cated in bits [22:21]. When clear, no flicker filtering is performed.
23 VIP_VIDEO_OK
(RO)
VIP Video OK (Read Only). This bit indicates the state of the internal VIP VIDEO_OK
input. This signal is driven by the VIP to indicate that the VIP is detecting a valid input
stream.
22 GENLOCK_
ACTIVE (RO)
GenLock Active (Read Only). This bit indicates that the current (or most recent) field/
frame was initiated as the result of an active VIP VSYNC. The state of this bit will change
coincident with the activation of the VSYNC output. If the VSYNC output occurs as the
result of a timeout condition, this bit will be cleared. If GenLock is not enabled
(GENLK_EN, bit 18 = 0), this bit will be cleared.
21 SKEW_WAIT
(RO)
Skew Wait (Read Only). This status bit indicates that the DC has received a VSYNC
from the VIP and that the skew counter is running. This bit is set when the VIP_VSYNC
input is set and cleared when the skew counter expires.