Filter
Top Products
EPSON Stylus Pro 7600/9600 Revision A
Troubleshooting Error Display 128
3.2.2.7 Type-B I/F error
3.2.2.8 Paper cutting error
3.2.2.9 Paper Not Straight
Table 3-11.
Item Description
LCD PANEL
MESSAGE
OPTION I/F ERROR
LED STATUS None
Explanation
A non-supported option Type-B I/F card is installed into the
printer.
This error occurs when the printer is turned on.
Recovery
Turn off the printer, remove the option Type-B I/F card, and then
turn on again.
If the error recurs, repeat checking by installing another Type-B
interface.
Table 3-12.
Item Description
LCD PANEL
MESSAGE
PAPER NOT CUT
LED STATUS “PAPER OUT” LED is blinking.
Explanation
The paper cannot cut whole paper completely by the cutter, or cut
paper remains over the front paper sensor.
Recovery
Remove the cut paper, or cut manually the paper using scissors
or else. User should lift the paper set lever and reset the paper or
push the Pause button. Thereby the printer will execute paper
initialize operation and will be printable status. In this time, if
the paper is so disarranged that it may cause head friction or
paper jam, user should cut the disarranged part neatly and reset
the paper. User should replace the cutter blade if it becomes
dull.
Checking the operation of the Cutter Solenoid:
Execute “Actuator 2 (p.229)” in the self-diagnostics menu and if
any problem is found, replace the actuator.
Table 3-13.
Item Description
LCD PANEL
MESSAGE
PAPER NOT STRAIGHT
LED STATUS “PAPER OUT” LED is blinking.
Explanation
When a skew exceed 3mm between top and end of the paper is
occur, user should confirm the previous printout because it may
not be printed completely. And also smudges on back of following
printouts may occur because of poured ink on the platen.
Recovery
This error is cleared by paper set operation.
• User should set the paper according the description of User's
guide exactly in order to prevent the occurrence of this error.
• The roll edge should be neatly arranged.
• This error can be prevented at following printing by paper set
operation.
This error may also cleared by turning OFF→ ON, but this error
may occur at following printing.