Filter
Top Products
EPSON Stylus Pro 7600/9600 Revision A
Disassembly & Assembly Disassembly and Assembly of Carriage (CR) Mechanism 183
4.3.9 CR_HP Sensor ASSY
1.
Remove the R Side Cover. (p.160)
2. While pushing the cutter area gently, shift the carriage to the left about 2 cm to unlock
the carriage and then move the carriage to the left from the capping position.
(See Figure 4-24)
3. Release the harness of the CR_HP Sensor ASSY from the four clamps on the printer
body.
(See Figure 4-46)
4. Pinch the two upper hooks of the CR_HP Sensor ASSY and disengage them from the
holding plate, and disconnect the connector.
(See Figure 4-47)
Figure 4-46. Releasing the CR_HP Sensor ASSY Harness
Figure 4-47. Removing the CR_HP Sensor
C A U T I O N
When unlocking the carriage, do not move the carriage by about 2
cm or more with the cutter pushed into the innermost position;
otherwise, the cutter edge would be damaged.
Clamp
Clamp
Clamp
CR_HP Sensor ASSY
Hook