Filter
Top Products
EPSON Stylus Pro 7600/9600 Revision A
Troubleshooting Error Display 146
3.2.4.35 Review error (0002000C)
Explanation:
There may be a case where the combination of the DIP Switch setting positions on
the Main Board is not supported by the firmware. In such a case, this message is
displayed and the printer stops operating.
Cause of trouble:
Driver circuit board review and the state of the DIP switch are not consistent with
the program version.
Remedy:
Check driver circuit board review and state of DIP switch.
Check the DIP Switch setting. (See p.209)
3.2.4.36 CPU address error (load misalignment) (100000E0)
Cause of trouble:
Defective circuit board or faulty CPU soldering. Program trouble or generation
error.
Remedy:
• Firmware Reinstallation (p.219)
• Replace the MAIN Board (C472 MAIN) (p.207).
3.2.4.37 CPU address error (storage misalignment) (10000100)
Cause of trouble:
Defective circuit board or faulty CPU soldering. Program trouble or generation
error.
Remedy:
• Firmware Reinstallation (p.219)
• Replace the MAIN Board (C472 MAIN) (p.207).
3.2.4.38 CPU reserve command code exception error (10000180)
Cause of trouble:
Defective circuit board or faulty CPU soldering. Program trouble or generation
error.
Remedy:
• Firmware Reinstallation (p.219)
• Replace the MAIN Board (C472 MAIN) (p.207).
3.2.4.39 CPU slot illegal command exception error (100001A0)
Cause of trouble:
Faulty CPU soldering. Program trouble or generation error.
Remedy:
• Firmware Reinstallation (p.219)
• Replace the MAIN Board (C472 MAIN) (p.207).
3.2.4.40 CPU DMA address error (100005C0)
Cause of trouble:
Defective circuit board or faulty CPU soldering. Program trouble or generation
error.
Remedy:
• Firmware Reinstallation (p.219)
• Replace the MAIN Board (C472 MAIN) (p.207).
3.2.4.41 CPU error (10000xxx)
Cause of trouble:
Defective circuit board or faulty CPU soldering. Program trouble or generation
error.
Remedy:
• Firmware Reinstallation (p.219)
• Replace the MAIN Board (C472 MAIN) (p.207).