Filter
Top Products
EPSON Stylus Pro 7600/9600 Revision A
Adjustment Overview 211
5.1 Overview
This section describes the adjustment procedures necessary after replacing certain parts
and explains how to perform those adjustment procedures.
5.1.1 Cautions
Before beginning the adjustment operation, be sure to confirm the following caution
items.
5.1.2 Adjustment Tools
Table below lists the tools necessary for adjustments of Stylus Pro 7600/9600.
Note "*": Use at adjustments which require test printing.
C A U T I O N
If you are carrying out adjustments, see “5.1.4 Adjustment
Items” (p.212) and then confirm the relevant adjustment items
and adjustment procedures.
When carrying out adjustments, check the cautions displayed
in the explanation for each adjustment item thoroughly. If the
operation is performed wrong, it could hinder the product's
operation or functions.
C H E C K
P O I N T
In adjustments and test printing, use Doubleweight Matte Paper
roll, unless otherwise specified.
Table 5-1. Adjustment Tools
Name Part Code Notes
Tension Gauge
#F770
1060744 / standard tool
acceptable
2.2kgf ± 220g
(PF Belt tension)
Thickness gauge Commercially available Thickness:
0.3 / 0.4 / 0.8 / 0.9 mm
Coupling tightening jig Tightening force: 3kgf + 500g
24/44-inch Width Roll Paper Epson or commercially
available paper
(Doubleweight Matte
Paper roll)
•MCSP24R4
(24-inch width)
•MCSP44R4
(44-inch width)
For printer mechanism
adjustments and test printing.
A3Tracing Paper
#F751
1057723 Used for adjustment of the
paper status detection sensor
(P_REAR) level adjustment.
Microtrace #300 LMB, made
by Kimoto
A3 Copy Paper (PPC) Commercially available
product
(Example: Fuji Xerox
Bright Recycled)
Used for adjustment of the
paper status detection sensor
(P_EDGE) level adjustment.
Scale 1000mm
#F713
1047746 / A
commercially available
scale can be purchased.
Length:1000mm
Scale Stopper
#F714
1047745 / A
commercially available
scale can be purchased.
Used in combination with the
#F713 (measurements in 0.1
mm units)
CR ENC sensor positioning jig
#F799
1212926
Cutter Positioning Jig
#F800
1212928
PF ENC sensor positioning tool
#F798
1212925
Ink Cartridge (x7)* Spare
Draining cartridge* Use at black ink type change
Maintenance Tank* Spare
Table 5-1. Adjustment Tools (continued)
Name Part Code Notes