Filter
Top Products
EPSON Stylus Pro 7600/9600 Revision A
Troubleshooting Error Display 129
3.2.2.10 Paper check error/Paper eject error (sheet) 3.2.2.11 Paper is too thick for cleaning
3.2.2.12 Not enough ink for cleaning
Table 3-14.
Item Description
LCD PANEL
MESSAGE
RELOAD PAPER
LED STATUS “PAPER OUT” LED is blinking.
Explanation
This error occur in following cases
1. The top length of ejected paper is too long to be back-fed
when paper is set.
2. Paper's horizontal position exceeds the normally printable area
when paper is set.
3. Paper's horizontal position exceeds the normal cutting
permission area just after printing.
4. Length of sheet exceeds the ejectable length and cannot be
ejected completely.
5. After recovery of cutter error.
See “3.2.2.8 Paper cutting error (p.128)”.
Recovery
In case of 1,2,3, user should set the paper again according the
User's guide exactly. If the top of the paper has indentation, it
should be trimmed. In case of 4,5, the ejected portion of paper top
should be removed and then user set paper again. User can cut the
portion using auto cutter after paper set lever is lifted up (in this
time, it shifts to “RELOAD PAPER”), horizontal position is reset
straight, paper set lever is pushed down, roll paper auto cut is
selected, and “Paper Cut/Eject” button is pushed if the paper
cutting is possible.
Table 3-15.
Item Description
LCD PANEL
MESSAGE
REMOVE PAPER
LED STATUS PAPER OUT LED is blinking.
Explanation
This error occurs when cleaning is executed although a paper
thickness of with1.2mm is set.
Recovery
Cleaning is executed automatically when paper is removed and the
paper set lever is set.
Table 3-16.
Item Description
LCD PANEL
MESSAGE
NOT ENOUGH INK
LED STATUS INK OUT LED goes on
Explanation
This error occurs when cleaning is executed although the amount
of ink necessary for cleaning is not left in each ink cartridge. The
amount of ink necessary differs with each cleaning. *Timer CL
and others are excluded.
Recovery
This error clears automatically after about 5 seconds. Error
message appears again during cleaning, unless all the installed
cartridges are replaced with ones with enough ink for cleaning.
The message “NOT ENOUGH INK” is displayed on the panel for
5 seconds. The corresponding “INK OUT” LED goes on for 5
seconds to alert the user to the error. The error is cleared by
pressing Pause button during the 5 second period.