Filter
Top Products
EPSON Stylus Pro 7600/9600 Revision A
Disassembly & Assembly Removing the Panel Unit and Housing 170
4.2.9 Front Cover
1. Open the Front Cover.
2. Push in the two hooks to the left of the cover and remove the Front Cover Support.
(See Figure 4-22)
3. Release the Front Cover Spring L from the Front Cover Spring Catch Shaft on the left
side of the Front Cover.
(See Figure 4-23)
4. Remove the Plastic Stop Wheel E5 on the left side of the Front Cover and move the
Front Cover Fulcrum Pin outward for its removal.
5. Release the Front Cover Spring R from the Front Cover Spring Catch Shaft on the right
side of the Front Cover.
6. Remove the Front Cover from the Front Cover Fulcrum Pin R.
Figure 4-22. Front Cover Support Removal
Figure 4-23. Front Cover Removal
Install the Plastic Stop Wheels in the correct orientations,
respectively.
A D J U S T M E N T
R E Q U I R E D
The cover switch holder installation position should be checked so
that the cover sensor ASSY is linked to the front cover when it
opens and closes.
Refer to “5.1.4.9 Cover Sensor ASSY Adjustment” (p.216)
Plastic Stop Wheel E5
Front Cover
Front Cover Fulcrum Pin L
Short
Long
Front Cover
Front Cover Support
Hooks
Front Cover Spring Catch Shaft
E-ring
Front Cover Spring L
Front Cover Spring R
Plastic Stop Wheel E
Front Cover Fulcrum Pin L
Front Cover Fulcrum Pin R
Front Cover