Filter
Top Products
EPSON Stylus Pro 7600/9600 Revision A
Product Description Operating Panel 56
1.4.3.31 User Paper Setting
Selecting this mode allows detection of the thickness of the available paper, and
registration of up to four user-defined paper.
Paper feeding adjustment, ink drying time, cutting method, MW print adjustment and
suction may be registered for each paper format.
Setting
1. Select user paper setting menu from the panel.
2. Select the paper number (‘STD’, ‘1’~‘10’)
3. Print the paper thickness detection pattern.
4. Check the printed adjustment patterns and enter the number of the pattern
with the least displacement for each adjustment item. (See p.58)
5. Enter cutting pressure.
6. Select cutting method.
7. Enter the paper feeding adjustment value.
8. Enter the ink dying time for each pass.
9. Select paper suction.
10. Select MW print quality adjustment.
NOTE 1: Paper setting can be made independently for any paper number.
2:
For details of patterns, refer to
“Print paper thickness detection pattern (p.
58)”
.
Paper setting and corresponding operation are as follows.
Details of each setting item are following;
Note 1: When “STD” is selected for Paper selection, Paper thickness detection pattern print,
Paper thickness number selection, Paper feeding adjustment setting items are not
displayed. Only when Paper “1” ~ “10” is selected, they are displayed.
2: During pattern printing, “PRINTING ALGNMNT PATTERN” is displayed.
(<\n> is new line)
3: Default display of paper thickness number selection is the number same as gap
adjustment.
Note *1: See “MW Printing Adjustment / Setting Values and Printing Modes (p.88)” for
selectable MW mode at MW print adjustment.
*2: It prints with PG small or PG big depending on detection result of paper thickness
sensor.
Table 1-38. Relationship between Pattern Numbers and Paper Thickness
Number1234567891011121314151617
Paper
thickness
0.0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1.0 1.1 1.2 1.3 1.4 1.5 1.6
Table 1-39.
Paper setup Operation
Standard When settings of cutting pressure ~ print quality are set with
commands, it follows the settings.
1 ~ 10 User definition paper. Even when cutting pressure ~ print quality are
set with commands, user setting value is used.
Table 1-40.
Setting Operation
Paper thickness Print paper thickness detection pattern and enter the paper thickness
number. (When “STD” is selected, it is not executed.)
*1
Cutting pressure Paper cutting pressure is set. Lower the pressure for thin and soft
paper. Manufacture setting value (75%) is displayed as 100%, which is
the maximum setting value to be assured. Setting available range is
110%~0%.
Cutting method Cutting method is selected, 4 step cutting for thin and soft paper. Paper
feed adjustment Paper feeding is adjusted. When 0.00% is not selected
for paper feed adjustment, it ignores driver command (SN 03H 00H
00H 04H m2) and setting value with SN menu of Maintenance mode1,
and uses this setting value.
Ink drying time Ink drying time for each pass is set.- The carriage stops at the right/left
sides of paper for setting time.
Paper suction Paper suction is set to make paper stable on the platen. Select “LOW”
for thin paper (film), which is difficult to feed.
MW print adjustment Micro weave mode is adjusted. When print speed has priority, lower
the setting value. When quality has priority, raise the setting value.
*2