Filter
Top Products
EPSON Stylus Pro 7600/9600 Revision A
Troubleshooting Error Display 130
3.2.2.13 Ink-related Errors
Ink End (error) : Ink end error occurs when the defined amount of ink
have been consumed after NearEnd is detected. It
occurs when NearEnd cartridge is inserted, whether the
defined amount of ink have been consumed or not.
No Ink Cartridge : There detected any ink cartridge slot without cartridge.
Wrong/Non-genuine Ink Cartridge (dye / pigment):
This error occurs when wrong ink type (dye / pigment)
is installed.
3.2.2.14 Defective ink cartridge
3.2.2.15 Ink lever released
Table 3-17.
Item Description
LCD PANEL
MESSAGE
“INK OUT”, “NO INK CARTRIDGE” or “INVALID
CARTRIDGE“
LED STATUS Corresponding color LED lights up
Recovery
Check the CSIC contact terminal on the I/C Holder and the CSIC
terminal on the ink cartridge. (damage or deformation)
If no problem with the CSIC terminals is found, install a new ink
cartridge.
Table 3-18.
Item Description
LCD PANEL
MESSAGE
INK OUT
LED STATUS
This error occurs when the ink cartridge CSIC has some problems
with the contents and has loose connection. Corresponded “INK
OUT” LED goes on.
Explanation
There detected some problems with the contents of the ink
cartridge CSIC. Reading/writing into ink cartridge was failed.
Recovery
In case of loose connection, release the ink lever (at this time the
massage “SET INK” is displayed and reload the ink cartridge.
When the error is not recovered, open the ink compartment, and
then replace cartridge with new full one.
Table 3-19.
Item Description
LCD PANEL
MESSAGE
SET INK LEVER
LED STATUS None
Explanation It is happen when ink lever is released.
Recovery Set the ink lever.