Filter
Top Products
Warning and error conditions
v
(warning) is displayed for the following conditions:
– Any subobject of the controller has any warning or error conditions.
v
(error) is displayed for the following conditions:
– The controller has failed.
– The controller has a bad configuration.
Actions
v Identify all physical drives
The
following actions are available only in bootable-CD mode:
v Configure RAID
v Delete all arrays
v Enable or disable unattended mode
Enabling
and disabling unattended mode:
Note: This action is supported in bootable-CD mode only.
Use this action to change the unattended-mode setting. This setting determines
how the ServeRAID Manager startup code (BIOS) handles failures during a system
startup. The default is Disabled.
1. In the Enterprise view, click
(controller).
2. Right-click Enable or Disable unattended mode.
3. Click Yes to confirm.
More information
v Understanding unattended mode
Identifying
devices: You can identify the devices in a server or enclosure, such as a
physical drive, because the light associated with the device you selected is flashing.
1. Click any object in the Physical devices view or Logical devices view, except
the following:
(Controller)
(CD-ROM drive)
(Tape drive)
(Removable-media drive)
2.
Right-click the appropriate Identify.
The ServeRAID Manager sends a command to the firmware (microcode) to
start flashing one or more physical drive or enclosure lights, depending on the
following:
v The selected object
v Whether the item and its subsystems are all controlled by an enclosure
device
Note:
Identify works only on controllers with a SAF-TE processor and the
appropriate firmware. If a device light or a series of device lights do not
flash, it is because all or part of the subsystem is not controlled by a
SAF-TE processor.
106 ServeRAID Manager Installation and User's Guide